Our Showroom is now closed for the foreseeable future and phone services are limited

  1. Home
  2. RC Electrics
  3. Receivers
  4. RadioLink R6DSM Micro 10 Channel SBUS Rx for Racing/FPV Drone. AT9/AT10
RadioLink R6DSM Micro 10 Channel SBUS Rx for Racing/FPV Drone. AT9/AT10
RadioLink R6DSM Micro 10 Channel SBUS Rx for Racing/FPV Drone. AT9/AT10

RadioLink R6DSM Micro 10 Channel SBUS Rx for Racing/FPV Drone. AT9/AT10

Write a Review
Your Price: £16.99 (£14.16 exc VAT)
This RadioLink R6DSM Micro 10 Channel SBUS Rx for Racing/FPV Drone. AT9/AT10 is manufactured by RadioLink and brought to you exclusively by KCR Distribution UK
Part Number: RL-R6DSM
Availability: Out of Stock.
In-store Pickup Available

Radiolink R6DSM, 2.4G 10 channels receiver, DSSS and FHSS spread spectrum working synchronously, 1 gram weight, SBUS and PPM signal support, use for Radiolink transmitters AT9, AT9S,AT10 and AT10II, the best choice for racing drones. 

Two Signal Modes:

  • Blue/purple LED, SBUS signal , 10 channels in Total.
  • Red LED , PPM signal, 10 channels in Total.

  

Switching SBUS and PPM Signal :

Short press the ID SET switch two times within 1 second, the signal is changed from SBUS to PPM. The red LED indicates the PPM and blue/purple indicates SBUS.

  

Binding:

  1. Place the transmitter and the receiver close to each other within 1 meter.
  2. Turn on the transmitter, then power on the R6DSM.
  3. There is a black button on the R6DSM, press the binding button twice in two seconds and release, receiver light start blinking, after about 8 times blinking, match code success when receiver signal LED always on!  

 

Installation Recommendations:

  1. The antenna must be kept as straight as possible. Otherwise it will reduce the effective range.
  2. Large model aircraft may have some metal parts interfering with signal; in this case the antennas should be placed at both sides of the model. Then the best RF signal condition is obtained at any flying attitude.
  3. The antennas must be kept away from conductive materials, such as metal and carbon by at least a half inch. The coaxial part of the antennas does not need to follow these guidelines, but do not bend it in a small radius.
  4. Keep the antennas away from the motor, ESC, and other noise sources as much as possible.

Specification:

  • Channels: 10 channels

  •  

    Working voltage: 4.8-6V

  •  

    Working current: 38-45mA(input voltage: 5V)

  •  

    Size: 15*13mm

  •  

    Weight: 1g

  •  

    Detachable antenna

  •  

    4096 precision, 0.25us per section.

  •  

    Control distance: about 600 meters, dependant on the environment.  

Reward Points

17 points will be rewarded to you when you buy this item.

Recently Viewed Items

Earn Rewards!